Fit Your Irons by Land Angle and Peak Height

An approach shot has one job: finish near where it landed. Carry distance tells you where the ball comes down. It says nothing about what happens next.

Two numbers do. Peak height is how high the ball climbs. Land angle is how steeply it is falling when it meets the ground. Every launch monitor reports both, most fittings glance past them, and between them they decide whether your 6-iron holds a green or only visits it.

Two shots, one carry distance. The high one comes down steeply and stops. The low one comes down flat and runs through the green.

What the two numbers mean

Land angle is measured up from the ground. A ball dropping straight down would land at 90 degrees, and a ball skimming in lands near zero. Some monitors call it descent angle, and some call peak height apex or max height. They are the same two measurements.

TrackMan states the consequence in one sentence: "All else equal, a lower (flatter) Landing Angle will create more bounce and roll."

The two numbers travel together. A ball that climbs higher comes down steeper. Height is also the one you can see with your own eyes on the range, which makes it the easier one to check without a machine.

What a tour bag looks like

TrackMan publishes averages for both tours. These are its 2023 figures: max height in yards, then land angle.

Club PGA Tour LPGA Tour
Driver 35 yd, 39° 26 yd, 36°
4-iron 31 yd, 49° 25 yd, 43°
7-iron 34 yd, 51° 26 yd, 47°
Pitching wedge 32 yd, 52° 27 yd, 48°

Source: TrackMan, Introducing Updated Tour Averages, May 2024.

Read down either column. The clubs carry very different distances, and every one of them peaks at nearly the same height. TrackMan makes the same point about the men's numbers: "the difference in Apex Height between Driver and Pitch Wedge is only 3 meters/yards."

That flat line across the bag is the thing to copy, not the yardages. GOLF.com's account of a Titleist fitting describes the aim as "ensuring every club in the bag reaches the same peak height."

Now read across. LPGA players are among the best ball strikers alive, and their 7-irons peak eight yards lower and land four degrees flatter than the men's. Speed buys height, and height buys land angle.

The number everyone quotes, and why it may not be yours

Ask for a target and you will hear 45 degrees. TrackMan's help pages say a landing angle "greater than 45 deg is recommended for all approach shots." Titleist says "Tour players are typically looking for a landing angle between 45° and 50°," and that below 45 the ball "tends to skip forward too far on the first bounce."

These are rules of thumb, and they are set at tour speed. PING's fitting science group published the more useful version: 7-iron land angles by club speed, sorted into three bands of what it calls stopping power.

7-iron club speed Low Mid High
60–70 mph 21°–28° 28°–35° 35°–42°
70–80 mph 29°–34° 34°–40° 40°–46°
80–90 mph 36°–40° 40°–44° 44°–49°
90–100 mph 41°–44° 44°–47° 47°–51°

Source: Chris Broadie, PING Proving Grounds, Stop It Like a Tour Player (archived copy; PING has since moved the page).

A golfer who swings a 7-iron at 75 mph and lands it at 43 degrees is in the high band. That is as good as that speed gets. Telling them to find 50 degrees is asking for a swing they do not have. The comparison that matters is the row you are in.

PING is careful about what the table is for: "Just because someone has 'low stopping power' with their irons does not mean they have to change their fitting. However, if a golfer struggles to hold greens with their 7-iron, then options should be discussed."

What strong lofts cost

Golf Digest reported in May 2025 that "the lofts of 7-irons considered for this year's Hot List ranged from 25 to 34 degrees." PING alone sells a 7-iron at 33 degrees, the Blueprint T, and one at 28, the G740. Both have a 7 on the sole.

Makers say the low, deep centre of gravity in a strong-lofted head puts the height back. Three independent tests say that is partly true.

  • Golf Digest had 20 low and middle handicap players hit the 2025 irons on a launch monitor: "For 7-irons with lofts of 30 degrees or less, the average landing angle was 3.5 degrees flatter than 7-irons with lofts of 33 degrees or more."
  • MyGolfSpy compared a blade 6-iron at 30 degrees of loft with a game-improvement 6-iron at 24. At stock lofts the blade landed at 43.47 degrees and the game-improvement iron at 39.86. Matched at 27 degrees, the blade's 5-iron against the game-improvement 6-iron bent weaker, they landed at 42.55 and 42.21. On landing angle the head made almost no difference. The loft made nearly all of it.
  • Andrew Rice hit three PING 7-irons himself on a TrackMan. The 29-degree G440 peaked at 88.4 feet and the 33-degree Blueprint S at 87.7. In his words, "the peak height was virtually identical with all three models." But the strong iron spun at 4,956 rpm against 5,710, landed at 44.5 degrees against 45.9, and ran 10.8 yards after landing against 8.3.

So the height claim holds up. What goes missing is spin and a degree or more of descent, and the ball runs further. That is the forgiveness bargain written in numbers. You get distance you can read on the sole, and you pay in stopping, which nothing on the club tells you about.

One player and twenty players are small samples. They agree with each other, and they agree with PING's own arithmetic for a single degree of loft: "1° less loft will increase ball speed by 1.5 mph; decrease launch angle by 0.5° and spin decreases by 200 rpm."

Where your irons should end

Speed sets the ceiling, and the ceiling drops as loft comes off. PING again: "As club speed increases, spin rate and landing angle both increase significantly." Kris McCormack of True Spec told GOLF.com that "too many players struggle with achieving a launch window that produces a manageable landing angle beyond their 7-iron."

The oldest advice in this article is also the most useful. Fitter Kevin Walker, on Golf Channel in 2009: "If you hit your 5-iron through pitching wedge at roughly 45 degrees, but your 3- and 4-irons come down at 35 degrees, then you need to replace your longer irons with hybrids to give you roughly the same landing angle."

Set makeup is a land-angle question. The longest iron you should carry is the last one that still climbs to your window.

How to run the test

  1. Get on a launch monitor that reports peak height and land angle, and bring the ball you play.
  2. Hit your 7-iron until you have ten solid strikes. Write down the average peak height and the average land angle. That height is your window.
  3. Find your row in PING's table. In the high band, the 7-iron is doing its job. In the low band, with greens that will not hold, something should change.
  4. Work up the bag one club at a time and write down the same two numbers for each.
  5. Mark the club where the height falls out of the window and the land angle goes with it. That club, and every iron longer than it, is a candidate for a hybrid or a lofted fairway wood that climbs back in.

When a club misses, PING lists the levers: "evaluate the iron model and lofts (retro or power spec); change launch conditions through shaft weight and flex; and even consider the model of golf ball." In plainer words, the fix is weaker lofts, a different head, a different shaft or a different ball. The same article gives the whole method in a line: "Instead of chasing distance, choose a 7-iron that leads to a playable landing angle with tighter dispersion and increased stopping power."

Why it matters more on firm ground

A soft green forgives a flat shot, because nearly anything stops on it. A firm green asks the flight to do the stopping. We could not find published measurements of roll against green firmness, so take this as reasoning from the physics above and not as data: the flatter the landing, the more bounce and roll, and firm turf gives back more of both.

If you go looking for firm and fast, your irons have to land better than those of a golfer who plays to soft greens.

Write the two numbers down beside every club in the bag. The number on the sole was never the specification.

Sources